@balance-recognition said in Line Cut:

@tree-dimension
Often misses and creates double vertex.
https://drive.google.com/file/d/16E_ht2dn-k6lMs7N8JhGi-xGgCS9zefJ/view?usp=share_link

thank you very much for the video! It helps seeing the problem, but we're still having issues trying to replicate it.

We've seen cases of "bad" snap coordinates in our testing (that will need fixing!), but couldn't reproduce the issue in the video where a line disappears entirely without creating the cut previewed earlier.

edited:

I think that I understand what's happening now (sorry the video helps but not seeing the hand/pencil still makes it difficult to guess)

if the cut is "confirmed" (double tapping) on an existing point it performs the cut. if the cut is "confirmed" (double tapping) in a place where there was no point before, it cancels the cut. (adds point temporarily but cancels it)

To clarify...

This should work:

Add point A Add point B Double tap on point B

If the following is done, it will "cancel" it:

Add point A Double tap point B

Can you confirm that this is the case for you?

Thank you very much!

Please note that the only UI setting that isn't stored (for now) are the "floated" coordinates of the shortcuts panel.

There's a small performance cost to having the panel floating around (instead of docked to the side panel) and this for now is a way to avoid this "cost" added even when it isn't needed. We also think that when the panel is floated the "good" floated coordinates might change across a session so having it in a certain X/Y place might not be useful after reopening/reorienting the device so not storing it in a way solves the two possible issues.

Hi!

You can save the startup material from the material parameters menu, press the floppy disk at the bottom-right corner. 
From that moment, new scenes should have the new “default material”.

IMG_DA1A83FD35BC-1.jpeg

Thank you very much!